FINCH 5332 In-Cab Display Decimal Point Setting
How to change the decimal point position on the FINCH 5332 In-Cab Display using the on-board jumper.
Reference
Decimal Point Pins and Jumper
The decimal point position is set with a black jumper on the row of pins at the upper left edge of the circuit board.
Procedure
Instructions
- 1
Open the Enclosure
Open the FINCH display enclosure by removing the 2 x Philips screws holding the top and bottom halves of the display enclosure together.
- 2
Power On
Turn on power to the system.
- 3
Locate the Circuit Board
See the circuit board with the decimal point pins and black jumpers facing up.
- 4
Find the Row of Pins
Find the row of pins along the upper left edge of the board.
- 5
Identify the Jumper
The black jumper sets the decimal point.
- 6
Set the Decimal Point
Place the jumper across the sets of pins until the correct decimal point position is displayed. Moving the jumper left moves the decimal point right. Moving the jumper right moves the decimal point left.
- 7
Power Off
Turn off power to the system.
- 8
Reassemble
Reassemble the display and secure the display firmly in place.