FINCH 5332 Jumpers & Connections
Configuring the internal jumpers
The FINCH 5332 Internal Display contains several jumper settings that allow configuration of decimal point placement, onboard relay logic, FILL/FALL alarm operation, and display of level readings below 2Lo.
Solder-side jumpers
On the FINCH 5332E, some jumpers are located on the solder side (back side) of the circuit board: J1, J10, and J2, J3, J4, and J5 (mounted in a row).
Decimal Point Configuration
The jumper positions of J2 through J5 determine the decimal point location displayed by the FINCH 5332E.
FINCH 5332E Jumper Placement
On the FINCH 5332E, jumper placement is located on the solder side of the circuit board.
FILL Relay Configuration
The FILL relay operation is controlled by Jumper J1 on the main circuit board.
| Position | Function |
|---|---|
| A (Left) | Relay contacts closed when alarming |
| B (Right) | Relay contacts open when alarming |
SPILL/FAIL Relay Configuration
The SPILL/FAIL relay operation is controlled by Jumper J10 on the main circuit board.
| Position | Function |
|---|---|
| A (Right) | Relay contacts closed when alarming |
| B (Left) | Relay contacts open when alarming |
Wiring Harness Connector
The image below shows the wiring harness connector for both the FINCH 5332 and FINCH 5332E.
Connector View: Outside View