The E0081 or E0082 error code blinking on your FINCH II Display usually means one of the following:
- Internal strapping table error
- No strapping table
Troubleshooting Steps
This is usually caused because your TD100 Transmitter:
- Wasn’t programmed during the system installation
- Was replaced for repair and wasn’t programmed
You will need to program or reprogram the transmitter with an updated strapping table.
Tip:
Click the TD100 Programming Guide link to walk you through how to program your hardware.
If the error does not get resolved by this, you possibly have a defective transmitter and need to get it replaced.
Need more help?
Contact one of our Titan Logix's Service Team members for more technical assistance.
Phone: 1-877-462-4085 (ext. 2)
Email: service@titanlogix.com
Documentation Support: https://www.titanlogix.com/support/downloads/